| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the cryptographic hardware accelerator driver of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a temporary denial of service (DoS) condition. The vulnerability exists because the affected devices have a limited amount of Direct Memory Access (DMA) memory and the affected software improperly handles resources in low-memory conditions. An attacker could exploit this vulnerability by sending a sustained, high rate of malicious traffic to an affected device to exhaust memory on the device. A successful exploit could allow the attacker to exhaust DMA memory on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| A vulnerability in the interaction between the Server Message Block (SMB) protocol preprocessor and the Snort 3 detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass the configured policies or cause a denial of service (DoS) condition on an affected device. This vulnerability is due to improper error-checking when the Snort 3 detection engine is processing SMB traffic. An attacker could exploit this vulnerability by sending a crafted SMB packet stream through an affected device. A successful exploit could allow the attacker to cause the Snort process to reload, resulting in a DoS condition. |
| A vulnerability in the IPv6 DHCP (DHCPv6) client module of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient validation of DHCPv6 messages. An attacker could exploit this vulnerability by sending crafted DHCPv6 messages to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: To successfully exploit this vulnerability, the attacker would need to either control the DHCPv6 server or be in a man-in-the-middle position. |
| A vulnerability in the management web server of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker with high privileges to execute configuration commands on an affected system.
This vulnerability exists because access to HTTPS endpoints is not properly restricted on an affected device. An attacker could exploit this vulnerability by sending specific messages to the affected HTTPS handler. A successful exploit could allow the attacker to perform configuration changes on the affected system, which should be configured and managed only through Cisco Firepower Management Center (FMC) Software. |
| Multiple vulnerabilities in the Server Message Block Version 2 (SMB2) processor of the Snort detection engine on multiple Cisco products could allow an unauthenticated, remote attacker to bypass the configured policies or cause a denial of service (DoS) condition on an affected device.
These vulnerabilities are due to improper management of system resources when the Snort detection engine is processing SMB2 traffic. An attacker could exploit these vulnerabilities by sending a high rate of certain types of SMB2 packets through an affected device. A successful exploit could allow the attacker to trigger a reload of the Snort process, resulting in a DoS condition.
Note: When the snort preserve-connection option is enabled for the Snort detection engine, a successful exploit could also allow the attacker to bypass the configured policies and deliver a malicious payload to the protected network. The snort preserve-connection setting is enabled by default. See the Details ["#details"] section of this advisory for more information.
Note: Only products that have Snort 3 configured are affected. Products that are configured with Snort 2 are not affected. |
| A vulnerability in the TLS handler of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to gain access to sensitive information.
This vulnerability is due to improper implementation of countermeasures against a Bleichenbacher attack on a device that uses SSL decryption policies. An attacker could exploit this vulnerability by sending crafted TLS messages to an affected device, which would act as an oracle and allow the attacker to carry out a chosen-ciphertext attack. A successful exploit could allow the attacker to perform cryptanalytic operations that may allow decryption of previously captured TLS sessions to the affected device. |
| A vulnerability in the Secure Sockets Layer (SSL) VPN functionality of the Cisco Adaptive Security Appliance (ASA) Software could allow an unauthenticated, remote attacker to cause a reload of the affected system or to remotely execute code. The vulnerability is due to an attempt to double free a region of memory when the webvpn feature is enabled on the Cisco ASA device. An attacker could exploit this vulnerability by sending multiple, crafted XML packets to a webvpn-configured interface on the affected system. An exploit could allow the attacker to execute arbitrary code and obtain full control of the system, or cause a reload of the affected device. This vulnerability affects Cisco ASA Software that is running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, ASA 1000V Cloud Firewall, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4110 Security Appliance, Firepower 9300 ASA Security Module, Firepower Threat Defense Software (FTD). Cisco Bug IDs: CSCvg35618. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to the affected software improperly validating IP Version 4 (IPv4) and IP Version 6 (IPv6) packets after the software reassembles the packets (following IP Fragmentation). An attacker could exploit this vulnerability by sending a series of malicious, fragmented IPv4 or IPv6 packets to an affected device. A successful exploit could allow the attacker to cause Snort processes on the affected device to hang at 100% CPU utilization, which could cause the device to stop processing traffic and result in a DoS condition until the device is reloaded manually. This vulnerability affects Cisco Firepower Threat Defense (FTD) Software Releases 6.2.1 and 6.2.2, if the software is running on a Cisco Firepower 2100 Series Security Appliance. Cisco Bug IDs: CSCvf91098. |
| Multiple vulnerabilities in the Application Layer Protocol Inspection feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerabilities are due to logical errors during traffic inspection. An attacker could exploit these vulnerabilities by sending a high volume of malicious traffic across an affected device. An exploit could allow the attacker to cause a deadlock condition, resulting in a reload of an affected device. These vulnerabilities affect Cisco ASA Software and Cisco FTD Software configured for Application Layer Protocol Inspection running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4100 Series Security Appliance, Firepower 9300 ASA Security Module, FTD Virtual (FTDv). Cisco Bug IDs: CSCve61540, CSCvh23085, CSCvh95456. |
| A vulnerability in the detection engine of Cisco Firepower Threat Defense software could allow an unauthenticated, remote attacker to bypass a configured Secure Sockets Layer (SSL) Access Control (AC) policy to block SSL traffic. The vulnerability is due to the incorrect handling of TCP SSL packets received out of order. An attacker could exploit this vulnerability by sending a crafted SSL connection through the affected device. A successful exploit could allow the attacker to bypass a configured SSL AC policy to block SSL traffic. Cisco Bug IDs: CSCvg09316. |
| A vulnerability in the Sourcefire tunnel control channel protocol in Cisco Firepower System Software running on Cisco Firepower Threat Defense (FTD) sensors could allow an authenticated, local attacker to execute specific CLI commands with root privileges on the Cisco Firepower Management Center (FMC), or through Cisco FMC on other Firepower sensors and devices that are controlled by the same Cisco FMC. To send the commands, the attacker must have root privileges for at least one affected sensor or the Cisco FMC. The vulnerability exists because the affected software performs insufficient checks for certain CLI commands, if the commands are executed via a Sourcefire tunnel connection. An attacker could exploit this vulnerability by authenticating with root privileges to a Firepower sensor or Cisco FMC, and then sending specific CLI commands to the Cisco FMC or through the Cisco FMC to another Firepower sensor via the Sourcefire tunnel connection. A successful exploit could allow the attacker to modify device configurations or delete files on the device that is running Cisco FMC Software or on any Firepower device that is managed by Cisco FMC. |
| A vulnerability in the FTP inspection engine of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. The vulnerability exists because the affected software fails to release spinlocks when a device is running low on system memory, if the software is configured to apply FTP inspection and an access control rule to transit traffic, and the access control rule is associated with an FTP file policy. An attacker could exploit this vulnerability by sending a high rate of transit traffic through an affected device to cause a low-memory condition on the device. A successful exploit could allow the attacker to cause a software panic on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| A vulnerability in the Session Initiation Protocol (SIP) inspection engine of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload or trigger high CPU, resulting in a denial of service (DoS) condition. The vulnerability is due to improper handling of SIP traffic. An attacker could exploit this vulnerability by sending SIP requests designed to specifically trigger this issue at a high rate across an affected device. Software updates that address this vulnerability are not yet available. |
| A vulnerability in the data acquisition (DAQ) component of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass configured access control policies or cause a denial of service (DoS) condition. The vulnerability exists because the affected software improperly manages system memory resources when inspecting traffic. An attacker could exploit this vulnerability by generating specific traffic patterns for the software to inspect. A successful exploit could allow the attacker to exhaust system memory resources used for traffic inspection. Depending on the configuration, the FTD Software could fail open and cease to inspect traffic or fail closed and result in a DoS condition. This vulnerability may require manual intervention to restore the software. |
| Multiple vulnerabilities in the Server Message Block (SMB) Protocol preprocessor detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent or remote attacker to cause a denial of service (DoS) condition. For more information about these vulnerabilities, see the Details section of this advisory. |
| A vulnerability in the CLI of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to perform a command injection attack. The vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by injecting commands into arguments for a specific command. A successful exploit could allow the attacker to execute commands with root privileges. |
| A vulnerability in the HTTP traffic filtering component of Cisco Firepower Threat Defense Software, Cisco FirePOWER Services Software for ASA, and Cisco Firepower Management Center Software could allow an unauthenticated, remote attacker to bypass filtering protections. The vulnerability is due to improper handling of HTTP requests, including those communicated over a secure HTTPS connection, that contain maliciously crafted headers. An attacker could exploit this vulnerability by sending malicious requests to an affected device. An exploit could allow the attacker to bypass filtering and deliver malicious requests to protected systems, allowing attackers to deliver malicious content that would otherwise be blocked. |
| A vulnerability in the TLS 1.3 implementation for a specific cipher for Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Cisco Secure Firewall Threat Defense (FTD) Software for Cisco Firepower 3100 and 4200 Series devices could allow an authenticated, remote attacker to consume resources that are associated with incoming TLS 1.3 connections, which eventually could cause the device to stop accepting any new SSL/TLS or VPN requests.
This vulnerability is due to the implementation of the TLS 1.3 Cipher TLS_CHACHA20_POLY1305_SHA256. An attacker could exploit this vulnerability by sending a large number of TLS 1.3 connections with the specific TLS 1.3 Cipher TLS_CHACHA20_POLY1305_SHA256. A successful exploit could allow the attacker to cause a denial of service (DoS) condition where no new incoming encrypted connections are accepted. The device must be reloaded to clear this condition.
Note: These incoming TLS 1.3 connections include both data traffic and user-management traffic. After the device is in the vulnerable state, no new encrypted connections can be accepted. |
| A vulnerability in how Cisco Firepower Threat Defense (FTD) Software handles session timeouts for management connections could allow an unauthenticated, remote attacker to cause a buildup of remote management connections to an affected device, which could result in a denial of service (DoS) condition. The vulnerability exists because the default session timeout period for specific to-the-box remote management connections is too long. An attacker could exploit this vulnerability by sending a large and sustained number of crafted remote management connections to an affected device, resulting in a buildup of those connections over time. A successful exploit could allow the attacker to cause the remote management interface or Cisco Firepower Device Manager (FDM) to stop responding and cause other management functions to go offline, resulting in a DoS condition. The user traffic that is flowing through the device would not be affected, and the DoS condition would be isolated to remote management only. |
| A vulnerability in the VPN System Logging functionality for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak that can deplete system memory over time, which can cause unexpected system behaviors or device crashes. The vulnerability is due to the system memory not being properly freed for a VPN System Logging event generated when a VPN session is created or deleted. An attacker could exploit this vulnerability by repeatedly creating or deleting a VPN tunnel connection, which could leak a small amount of system memory for each logging event. A successful exploit could allow the attacker to cause system memory depletion, which can lead to a systemwide denial of service (DoS) condition. The attacker does not have any control of whether VPN System Logging is configured or not on the device, but it is enabled by default. |