| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: validate connectionless PSM length
Connectionless L2CAP frames carry a two-byte PSM at the start of the
payload. l2cap_recv_frame() currently reads that PSM unconditionally
after validating only the outer L2CAP length.
A malformed connectionless frame with a zero- or one-byte payload can
therefore make the parser read beyond the advertised skb payload and use
tailroom bytes as part of the PSM. A VHCI-backed QEMU reproducer
injected a one-byte connectionless payload and reached the unchecked
read.
Reject connectionless frames that cannot contain the PSM before reading
or pulling it. This preserves all valid connectionless frames while
dropping only structurally incomplete packets. |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: validate inline dentry name lengths before conversion
Inline dentry conversion copies names out of the inline dentry area
before checking that each recorded name length fits in the available
filename slots.
A corrupted image can therefore make the conversion path read past
the inline filename storage while building the regular dentry block.
Validate each inline dentry name length against the inline filename
area before copying it. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: caiaq: validate EP1 reply lengths
usb_ep1_command_reply_dispatch() uses buf[0] as a command byte and then
reads command-specific fixed items from the same URB buffer. Several
paths use buf + 1, buf[1], buf[2], or buf + 3 without first proving that
urb->actual_length contains those bytes.
Add per-command length checks, use a payload length derived from the
bytes after the command byte for the control-state copy, and reject short
analog input payloads before the input helper reads fixed offsets from
the EP1 reply. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rsi: avoid reading TKIP MIC keys for non-TKIP ciphers
rsi_hal_load_key() copies tx_mic_key and rx_mic_key from data[16] and
data[24] whenever key data is present. Those offsets are only part of
the 32-byte TKIP key layout. Shorter keys used by other ciphers, such as
CCMP, do not provide those bytes, so the unconditional copies can read
past the supplied key buffer.
Only copy the MIC keys for TKIP, and reject malformed TKIP keys that are
shorter than the expected 32-byte layout.
[drop useless length check] |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: validate assoc response length before status and IE access
cfg80211_rx_assoc_resp() initialises the status and response-IE fields
of cfg80211_connect_resp_params from the management frame before
proving that the frame is long enough for those offsets. S1G and
regular association responses also have different IE offsets, but the
S1G path only patched resp_ie after the unsafe initialiser had already
run.
Defer resp_ie, resp_ie_len, and status to after the link-iteration
loop. Use a bool to remember whether the frame is S1G, then validate
the appropriate minimum length and set all three fields in a single
if/else block. Funnel short-frame and SME-reject cleanup through a
shared free_bss label for the abandon paths. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: validate rx/tx MLME callback frame lengths before access
cfg80211_rx_mlme_mgmt() and cfg80211_tx_mlme_mgmt() call tracepoints
before rejecting frames shorter than the frame-control field. After
that, they only require len >= 2 before dispatching into subtype
handlers that assume their fixed fields are present.
The frames that trip this are not shorter than 2 bytes; they are short
relative to their subtype. mwifiex is a concrete in-tree example on the
length side: mwifiex_process_mgmt_packet() only requires a 4-address
ieee80211_hdr plus the 2-byte firmware length prefix before handing the
frame to cfg80211_rx_mlme_mgmt(). After stripping the length prefix and
removing addr4, pkt_len can be exactly 24: a bare 3-address management
header with no reason-code body. The existing WARN_ON(len < 2) does not
fire on such a frame, and cfg80211_process_deauth() then reads
u.deauth.reason_code as a two-byte access starting at offset 24,
immediately past the 24-byte buffer.
Add a frame-control length gate, then validate each subtype's minimum
frame size in an if/else-if chain that mirrors the dispatch logic. Trace
only after the frame is known to be well-formed.
Side effects of this change:
- The WARN_ON(len < 2) is dropped. It only guarded the frame_control
read, never the subtype fixed fields, and it does not fire on the
frames that actually trigger the out-of-bounds read (which are >= 2).
The len >= 2 check is kept as the guard before dereferencing
frame_control, but without the warning: these are exported callbacks
and a malformed frame from a driver should be dropped silently rather
than backtraced.
- cfg80211_tx_mlme_mgmt() previously routed every non-deauth subtype
through disassociation handling; it now silently ignores unrecognised
subtypes. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: libipw: fix key index receive bound checks
libipw_rx() reads skb->data[hdrlen + 3] to extract the WEP key index in
both the software-decrypt key selection path and the hardware-decrypted
IV/ICV strip path. In both places the existing guard only checks
skb->len >= hdrlen + 3, which proves bytes up to hdrlen + 2 but not the
byte at hdrlen + 3.
Require hdrlen + 4 bytes before reading that item in both paths. This is
a local source-boundary check only; it does not change the key index
semantics. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rsi: validate beacon length before fixed buffer copy
rsi_prepare_beacon() copies the mac80211 beacon frame after
FRAME_DESC_SZ into a management skb whose usable tailroom may be smaller
than MAX_MGMT_PKT_SIZE after alignment.
Validate the beacon length against the actual tailroom before the copy
and skb_put(). Leave ownership of the management skb with the caller on
error, matching the existing rsi_send_beacon() cleanup path. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mvm: validate sta_id in BA window status notif
BA_WINDOW_STATUS_NOTIFICATION_ID extracts a 5-bit sta_id from the
firmware notification and uses it to index fw_id_to_mac_id[] without
bounds checking. Validate sta_id before array access to prevent
out-of-bounds indexing. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mvm: fix an off-by-1 boundary check
Before looking at the 11th byte, check the length is big enough. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mvm: fix a possible underflow
We shouldn't trust the firmware about the length of the wowlan packet. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mvm: add a check on the tid coming from the firmware
ba_notif->tid is a firmware-controlled u8 that is used directly
as an array index into tid_data[] without any validation. Add a
bounds check against IWL_MAX_TID_COUNT before dereferencing the
array. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: bound aligned TLV advance in FW parser
Validate ALIGN(tlv_len, 4) against remaining parser length before
consuming bytes from the firmware image.
This avoids length underflow on malformed TLVs. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: acpi: validate WGDS table revision index
Check tbl_rev bounds before BIT(tbl_rev) to avoid undefined shifts when
firmware reports an invalid revision value. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: bound dirent name against end of SMB response in cifs_filldir
cifs_filldir() copies the entry name out of an SMB1 TRANS2_FIND_FIRST /
FIND_NEXT response using a length (de.namelen) supplied by the server.
The kmalloc'd SMB response buffer is bounded, but nothing checks that
de.name + de.namelen still lies inside that buffer before the eventual
filldir64() -> verify_dirent_name() -> memchr() reads namelen bytes.
A hostile SMB1 server that returns an oversized FileNameLength in a
directory entry therefore causes memchr() to read past the end of the
response slab buffer. Reachable from any user who can list a directory
on a CIFS mount served by an attacker-controlled server (getdents64()
on the mounted directory):
BUG: KASAN: slab-out-of-bounds in memchr+0x71/0x80
Read of size 1 at addr ffff88800e0640cc by task poc/115
Call Trace:
dump_stack_lvl+0x64/0x80
print_report+0xce/0x620
kasan_report+0xec/0x120
memchr+0x71/0x80
filldir64+0x4c/0x6a0
cifs_filldir.constprop.0+0x9bb/0x1e00
cifs_readdir+0x2101/0x3380
iterate_dir+0x19c/0x520
__x64_sys_getdents64+0x126/0x210
do_syscall_64+0x107/0x5a0
entry_SYSCALL_64_after_hwframe+0x77/0x7f
Pass the end-of-response pointer down to cifs_filldir() and reject
entries whose name would extend past that boundary.
This bug was discovered by Artiphishell's vTriage pipeline, which
generated a userspace reproducer (an emulated hostile SMB1 server plus
a getdents64() client) that reliably triggers the KASAN report on an
unpatched kernel. The fix below was drafted with the Claude coding
assistant; a userspace reproducer is available on request. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: validate IEs in cfg80211_wext_siwgenie()
The KASAN allocation trace shows that a malformed IE buffer is
stored via SIOCSIWGENIE (cfg80211_wext_siwgenie()) without any
validation. The crash trace shows that a subsequent SIOCSIWESSID
triggers a connection attempt which calls cfg80211_sme_get_conn_ies()
to process the stored IE buffer, causing:
- An out-of-bounds read in skip_ie() which reads ies[pos+1]
(the length byte) past the end of the 1-byte buffer.
- An integer underflow in the memcpy size argument when offs
returned by ieee80211_ie_split() exceeds ies_len, causing
unsigned subtraction to wrap to SIZE_MAX and triggering a
fortify panic.
Fix this by validating the IE buffer in cfg80211_wext_siwgenie()
before storing it.
[drop unnecessary ie_len check, update commit message] |
| In the Linux kernel, the following vulnerability has been resolved:
drm/sysfb: simpledrm: Improve stride validation
Validate the computed stride against the maximum value INT_MAX. |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: validate MOVE_RANGE destination size
F2FS_IOC_MOVE_RANGE checks the source range, but not the destination end
before updating i_size. A source hole can expose this: __clone_blkaddrs()
skips NULL_ADDR entries and returns success, so the caller can still extend
the destination inode with unchecked pos_out + len.
Reject destination overflow and use inode_newsize_ok() before extending
the destination inode. |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: limit recovery filename logging to stored length
F2FS stores recovery filenames as a length plus a fixed-size i_name
buffer. The buffer is not NUL-terminated, but recover_inode() and
recover_dentry() print it with %s.
For a 255-byte filename, recovery logging can read past i_name into the
following raw inode fields.
Print the name with a precision bounded by i_namelen and F2FS_NAME_LEN. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/sysfb: ofdrm: Fix integer overflow in fb_size calculation
The framebuffer size calculation `fb_size = linebytes * height` can
overflow when both values are large (e.g., 46341 * 46341 > INT_MAX).
Since linebytes and height are both int types, the multiplication is
performed as int * int, which results in undefined behavior on overflow.
Use check_mul_overflow() to detect and prevent this overflow, consistent
with the approach used in simpledrm.c and corebootdrm.c. |
