| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx4: Fix resource leak on error in mlx4_ib_create_srq()
Sashiko points out that mlx4_srq_alloc() was not undone during error
unwind, add the missing call to mlx4_srq_free(). |
| In the Linux kernel, the following vulnerability has been resolved:
spi: microchip-core-qspi: control built-in cs manually
The coreQSPI IP supports only a single chip select, which is
automagically operated by the hardware - set low when the transmit
buffer first gets written to and set high when the number of bytes
written to the TOTALBYTES field of the FRAMES register have been sent on
the bus. Additional devices must use GPIOs for their chip selects.
It was reported to me that if there are two devices attached to this
QSPI controller that the in-built chip select is set low while linux
tries to access the device attached to the GPIO.
This went undetected as the boards that connected multiple devices to
the SPI controller all exclusively used GPIOs for chip selects, not
relying on the built-in chip select at all. It turns out that this was
because the built-in chip select, when controlled automagically, is set
low when active and high when inactive, thereby ruling out its use for
active-high devices or devices that need to transmit with the chip
select disabled.
Modify the driver so that it controls chip select directly, retaining
the behaviour for mem_ops of setting the chip select active for the
entire duration of the transfer in the exec_op callback. For regular
transfers, implement the set_cs callback for the core to use.
As part of this, the existing setup callback, mchp_coreqspi_setup_op(),
is removed. Modifying the CLKIDLE field is not safe to do during
operation when there are multiple devices, so this code is removed
entirely. Setting the MASTER and ENABLE fields is something that can be
done once at probe, it doesn't need to be re-run for each device.
Instead the new setup callback sets the built-in chip select to its
inactive state for active-low devices, as the reset value of the chip
select in software controlled mode is low. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: Fix pin leak and publication ordering in __pkvm_init_vcpu()
Two bugs exist in the vCPU initialisation path:
1. If a check fails after hyp_pin_shared_mem() succeeds, the cleanup
path jumps to 'unlock' without calling unpin_host_vcpu() or
unpin_host_sve_state(), permanently leaking pin references on the
host vCPU and SVE state pages.
Extract a register_hyp_vcpu() helper that performs the checks and
the store. When register_hyp_vcpu() returns an error, call
unpin_host_vcpu() and unpin_host_sve_state() inline before falling
through to the existing 'unlock' label.
2. register_hyp_vcpu() publishes the new vCPU pointer into
'hyp_vm->vcpus[]' with a bare store, allowing a concurrent caller
of pkvm_load_hyp_vcpu() to observe a partially initialised vCPU
object.
Ensure the store uses smp_store_release() and the load uses
smp_load_acquire(). While 'vm_table_lock' currently serialises the
store and the load, these barriers ensure the reader sees the fully
initialised 'hyp_vcpu' object even if there were a lockless path or
if the lock's own ordering guarantees were insufficient for nested
object initialization. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/mana: Fix error unwind in mana_ib_create_qp_rss()
Sashiko points out that mana_ib_cfg_vport_steering() is leaked, the normal
destroy path cleans it up. |
| Inappropriate implementation in Extensions in Google Chrome prior to 149.0.7827.103 allowed a remote attacker who had compromised the renderer process to bypass site isolation via a crafted HTML page. (Chromium security severity: High) |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix fsck inconsistency caused by FGGC of node block
During FGGC node block migration, fsck may incorrectly treat the
migrated node block as fsync-written data.
The reproduction scenario:
root@vm:/mnt/f2fs# seq 1 2048 | xargs -n 1 ./test_sync // write inline inode and sync
root@vm:/mnt/f2fs# rm -f 1
root@vm:/mnt/f2fs# sync
root@vm:/mnt/f2fs# f2fs_io gc_range // move data block in sync mode and not write CP
SPO, "fsck --dry-run" find inode has already checkpointed but still
with DENT_BIT_SHIFT set
The root cause is that GC does not clear the dentry mark and fsync mark
during node block migration, leading fsck to misinterpret them as
user-issued fsync writes.
In BGGC mode, node block migration is handled by f2fs_sync_node_pages(),
which guarantees the dentry and fsync marks are cleared before writing.
This patch move the set/clear of the fsync|dentry marks into
__write_node_folio to make the logic clearer, and ensures the
fsync|dentry mark is cleared in FGGC. |
| In the Linux kernel, the following vulnerability has been resolved:
ice: fix double free in ice_sf_eth_activate() error path
When auxiliary_device_add() fails, ice_sf_eth_activate() jumps to
aux_dev_uninit and calls auxiliary_device_uninit(&sf_dev->adev).
The device release callback ice_sf_dev_release() frees sf_dev, but
the current error path falls through to sf_dev_free and calls
kfree(sf_dev) again, causing a double free.
Keep kfree(sf_dev) for the auxiliary_device_init() failure path, but
avoid falling through to sf_dev_free after auxiliary_device_uninit(). |
| In the Linux kernel, the following vulnerability has been resolved:
spi: ch341: fix devres lifetime
USB drivers bind to USB interfaces and any device managed resources
should have their lifetime tied to the interface rather than parent USB
device. This avoids issues like memory leaks when drivers are unbound
without their devices being physically disconnected (e.g. on probe
deferral or configuration changes).
Fix the controller and driver data lifetime so that they are released
on driver unbind.
Note that this also makes sure that the SPI controller is placed
correctly under the USB interface in the device tree. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Clear VRAM on allocation to prevent stale data exposure
KFD VRAM allocations set AMDGPU_GEM_CREATE_VRAM_WIPE_ON_RELEASE
but not AMDGPU_GEM_CREATE_VRAM_CLEARED, leaving freshly allocated
VRAM with stale data from prior use observable by compute kernels.
The GEM ioctl path already sets VRAM_CLEARED for all userspace
allocations via amdgpu_gem_create_ioctl() and
amdgpu_mode_dumb_create(). The KFD path was missing this flag,
allowing stale page table remnants to leak into user buffers.
This causes crashes in RCCL P2P transport where non-zero data in
ptrExchange/head/tail fields corrupts the protocol handshake. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: bla: put backbone reference on failed claim hash insert
When batadv_bla_add_claim() fails to insert a new claim into the hash, it
leaked a reference to the backbone_gw for which the claim was intended.
Call batadv_backbone_gw_put() on the error path to release the reference
and avoid leaking the backbone_gw object. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: playstation: Clamp num_touch_reports
A device would never lie about the number of touch reports would it?
If it does the loop in dualshock4_parse_report will read off the end of
the touch_reports array, up to about 2 KiB for the maximum number of 256
loop iteraions. The data that is read is emitted via evdev if the
DS4_TOUCH_POINT_INACTIVE bit happens to be set. Protect against this by
clamping the num_touch_reports value provided by the device to the
maximum size of the touch_reports array. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: bla: only purge non-released claims
When batadv_bla_purge_claims() goes through the list of claims, it is only
traversing the hash list with an rcu_read_lock(). Due to a potential
parallel batadv_claim_put(), it can happen that it encounters a claim which
was actually in the process of being released+freed by
batadv_claim_release(). In this case, backbone_gw is set to NULL before the
delayed RCU kfree is started. Calling batadv_bla_claim_get_backbone_gw() is
then no longer allowed because it would cause a NULL-ptr derefence.
To avoid this, only claims with a valid reference counter must be purged.
All others are already taken care of. |
| In the Linux kernel, the following vulnerability has been resolved:
media: saa7164: add ioremap return checks and cleanups
Add checks for ioremap return values in saa7164_dev_setup(). If
ioremap for BAR0 or BAR2 fails, release the already allocated PCI
memory regions, remove the device from the global list, decrement
the device count, and return -ENODEV.
This prevents potential null pointer dereferences and ensures proper
cleanup on memory mapping failures. |
| In the Linux kernel, the following vulnerability has been resolved:
media: rc: xbox_remote: heed DMA restrictions
The buffer for IO must not be part of the device structure
because that violates the DMA coherency rules. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: stop caching unowned originator pointers in BAT IV
BAT IV keeps the last-hop neighbor address in each neigh_node, but some
paths also cache an originator pointer derived from a temporary lookup.
That pointer is not owned by the neigh_node and may no longer refer to a
live originator entry after purge handling runs.
Stop storing the auxiliary originator pointer in the BAT IV neighbor
state. When BAT IV needs the neighbor originator data, resolve it from
the stored neighbor address and drop the reference again after use.
[sven: avoid bonding logic for outgoing OGM] |
| In the Linux kernel, the following vulnerability has been resolved:
media: i2c: ov5647: Fix runtime PM refcount leak in s_ctrl
Three control cases (AUTOGAIN, EXPOSURE_AUTO, ANALOGUE_GAIN) directly
return without calling pm_runtime_put(), causing runtime PM reference
count leaks.
Change these cases from 'return' to 'ret = ... break' pattern to ensure
pm_runtime_put() is always called before function exit. |
| In the Linux kernel, the following vulnerability has been resolved:
media: iris: Fix use-after-free in iris_release_internal_buffers()
The recent change in commit 1dabf00ee206 ("media: iris: gen1: Destroy
internal buffers after FW releases") introduced a regression where
session_release_buf() may free the buffer. The caller,
iris_release_internal_buffers(), continued to access `buffer` after the
call, leading to a potential use-after-free.
Fix this by setting BUF_ATTR_PENDING_RELEASE before calling
session_release_buf(), and reverting the flag if the call fails. This
ensures no dereference occurs after potential freeing. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: mpc52xx: fix use-after-free on registration failure
Make sure to disable and free the interrupts in case controller
registration fails to avoid a potential use-after-free and resource
leak.
This issue was flagged by Sashiko when reviewing a controller
deregistration fix. |
| Inappropriate implementation in V8 in Google Chrome prior to 146.0.7680.153 allowed a remote attacker to execute arbitrary code inside a sandbox via a crafted HTML page. (Chromium security severity: High) |
| Insufficient validation of untrusted input in Input in Google Chrome prior to 149.0.7827.103 allowed a remote attacker to perform UI spoofing via a crafted HTML page. (Chromium security severity: High) |
